|
BLUZ
BROZ.
ENTERTAINMENT
|
|||
PHONE HOURS
(E.S.T.): |
Automotive Security Systems |
VSE
Vehicle Security
Electronics
VSE |
|
ALARM SYSTEMS |
|
Derringer II VS-8900
The IASCA SHOW CAR Favorite. |
|
Sorry... This complete product is
UNAVAILABLE at
this time. Thank you. |
|
Stealth Plus VS-9100
A Very Affordable Comprehensive Automotive Security System. |
|
Sorry... This complete product is
UNAVAILABLE at
this time. Thank you. |
|
Stealth VS-8890
|
|
Sorry... This complete product is
UNAVAILABLE at
this time. Thank you. |
|
VSE ACCESSORIES |
|
VS-0046P
DESCRIPTION: The VSE VS-0046P In-Line Fuse Holder is used in many automotive alarm system applications where a Heat Resistant and Water Resistant Bakelite Case is beneficial. The wire is 12 gauge and it will accept up to a 50 Amp standard AGC Type GlassFuse. |
84 |
YOUR COST $ 4.93 EACH |
|
VS-0150
DESCRIPTION: The VSE VS-0150 SPST 30/40 Amp Relay is used in many automotive alarm system applications where a high current switching capacity is required. It has a high temperature design and is equipped with a convenient mounting tab. |
110 |
YOUR COST $ 7.48 EACH |
|
VS-0401P
DESCRIPTION: The VSE VS-0401P diode is used in many automotive alarm system applications where a degree of isolation is necessary between triggers or sensors.
|
96 |
YOUR COST $ 3.90 EACH |
|
VS-1003
DESCRIPTION: The VSE SHATTERGUARD (Model VS-1003) is an integral part of any VSE automotive security system. It has a dual task as a glass breakage detector and a system condition annunciation device.
|
10 |
YOUR COST $51.34 EACH |
|
VS-1027P
DESCRIPTION: The VSE VS-1027P is an automobile pin switch, N/C for hood, trunk, or door use. It accepts .156" male bullet connector. |
27 |
YOUR COST $ 6.58 EACH |
|
VS-1030
The
VSE AccuSensor
(Model VS-1030)
is a
revolutionary shock sensor (Impact Sensor). It is revolutionary
because the design allows it to be very finely calibrated by learning the
EXACT level of sensitivity required. |
6 |
YOUR COST $96.42 EACH |
|
VS-1045
DESCRIPTION: The VSE VS-1045 is use when the ultimate in detection is required. This is a flexible pad of 8 inches length that fits under your seat pad, but on top of the seat springs. It is a NO circuit until pressure is applied by sitting on the seat. Other pressure applications can be made with this item.
|
6 |
YOUR COST $39.40 EACH |
|
VS-2030
DESCRIPTION: The VSE VS-2030 is a mid-sized, high powered single tone siren with a 125 dB output that is just on the trailing edge of most city noise pollution standards.
|
3 |
YOUR COST $47.94 EACH |
|
VS-3525
DESCRIPTION:
The
VSE VS-3525
is used in
the 1985 model year American-Spec Mercedes Benz vehicles that are equipped
with the new "Three Point Central Locking System." PLEASE NOTE: Additional technical details are available upon request or will be supplied with the module.
|
2 |
YOUR COST $61.80 EACH |
|
VS-3877
DESCRIPTION: The VSE VS-3877 battery is used in the VSE STEALTH VS-8701 and the VSE DERRINGER 2 VS-8702 transmitters. This a 3.0 volt, high current lithium coin type battery. Two (2) batteries are required for these transmitters. PLEASE NOTE: DO NOT SUBSTITUTE ANOTHER BATTERY! |
92 |
YOUR COST $ 5.00 EACH --------------------------------------- YOUR COST is $ 3.95 EACH when you purchase SIX (6) UNITS or more.
|
|
VS-8610
DESCRIPTION: The VSE VS-8610 is used in the VSE QUANTUM Automotive Security System in order to add as many as 10 additional remote controlled functions. PLEASE NOTE: Additional technical details are available upon request or will be supplied with the module. |
2 |
YOUR COST $71.18 EACH |
|
VS-8675A
DESCRIPTION:
The
VSE VS-8675A
is used in
the VSE Automotive Security Systems in order to allow the systems to
remotely activate via the wireless transmitters.
|
3 |
YOUR COST $72.55 EACH |
|
VS-8701
DESCRIPTION: The VSE VS-8701 Wireless Transmitter is used to control the VSE STEALTH and VSE STEALTH + Automotive Security Systems. This is a 1-Button Transmitter.
|
2 |
YOUR COST $100.00 EACH |
|
VS-8702
DESCRIPTION: The VSE VS-8702 Wireless Transmitter is used to control the VSE DERRINGER 2 Automotive Security Systems. This is a 2-Button Transmitter.
|
0 |
YOUR COST $125.00 EACH |
|
VS-8677C
DESCRIPTION:
The
VSE VS-8677C
is used in
the VSE Automotive Security Systems in order to allow the systems to connect
to the RF Receiver Module. This link allows the alarm system to be
remotely activated via the wireless transmitters. This cable is 6' 9" in
length.
|
5 |
YOUR COST $12.75 EACH |
|
VS-GLED
DESCRIPTION: The VSE VS-GLED is used with all VSE Automotive Security Systems as well as many others. It is used as a visual indicator for alarm functions.
|
5 |
YOUR COST $8.85 EACH |
|
VS-RLED
DESCRIPTION: The VSE VS-RLED is used with all VSE Automotive Security Systems as well as many others. It is used as a visual indicator for alarm functions.
|
6 |
YOUR COST $8.85 EACH |
|
VS-YLED
DESCRIPTION: The VSE VS-YLED is used with all VSE Automotive Security Systems as well as many others. It is used as a visual indicator for alarm functions.
|
6 |
YOUR COST $8.85 EACH |
|
Return to ALARM HOME PAGE |
RELATED PRODUCTS |
Can't decide on a model?
We'll be glad to help
you choose the right
We'll be glad to help you select the proper Professional and Consumer Equipment for your needs!
PLEASE NOTE: |
VSE - Vehicle Security Electronics Automotive Security Systems Page